LED Wall Sconce White Aluminum Up Down Oval

This is the quiet version of an up and down sconce. There is no exposed bulb and no hard edge. A shallow white oval sits almost flat on the wall and pushes light out of two long slots, one at the top and one at the bottom. At 3.9 in tall it is small enough for a corridor where anything deeper would be in the way.

Two Soft Bands Instead of a Beam

The slots are long and narrow rather than round openings.

That spreads the light sideways as it travels up the wall.

You get two soft bands rather than two sharp cones.

The effect is gentler than a tube sconce and easier to live with.

In a bathroom it flatters rather than casting hard shadows.

Beside a mirror, a pair gives even light across a face.

In a corridor it marks the wall without dazzling anyone walking past.

Give it clear wall above and below so both bands land.

Mount it about 60 in off the floor in a hallway.

It is an indoor fitting, so it is not rated for an outside wall.

In a bathroom, keep it away from the shower zone.

Check local rules for bathroom wiring before fitting one near a basin.

The Two Widths

The 6.3 in version runs at 3W and is the discreet one.

Use it in a tight corridor or as a pair beside a mirror.

The 9.8 in version runs at 5W and covers more wall.

It suits a living room or a wider stretch beside a bed.

Both are 3.9 in tall, so they project the same amount.

Only the width and the output change between them.

In a run along one wall, keep to a single width.

The larger one is the safer pick if it is the only light.

Because both sizes are the same height, a mixed run still lines up.

Only the width changes, so the bands sit at the same level.

That is useful if one stretch of wall is tighter than the rest.

White Finish and Fitting

Every version is white, so there is no finish decision to make.

White reads as part of the wall rather than as hardware.

That is the point of it in a corridor or a bathroom.

On a dark wall the shape stands out as a pale block.

On white plaster only the light itself is visible.

It is hardwired, so a point is needed at the right height.

The LED is integrated and the fixture is not serviceable.

At 1.5 lb it needs only standard wall anchors.

The supplier lists CE and CCC certifications.

Bulbs are listed as included, which here means the integrated LED.

The fixture cannot be relamped, so treat it as a sealed unit.

We accept returns for damaged or unused items within 14 days of purchase. Your satisfaction is our priority.